Masons

Cement masons and concrete finishers place and finish the concrete. They also may color concrete surfaces; expose aggregate (small stones) in walls and sidewalks; or fabricate concrete beams, columns, and panels. In preparing a site for placing concrete, cement masons first set the forms for holding the concrete and properly align them. They then direct the casting of the concrete and supervise laborers who use shovels or special tools to spread it. Masons then guide a straightedge back and forth across the t op of the forms to “screed,” or level, the freshly placed concrete. Immediately after leveling the concrete, masons carefully smooth the concrete surface with a “bull float,” a long-handled tool about 8 by 48 inches that covers the coarser materials in the concrete and brings a rich mixture of fine cement paste to the surface.

After the concrete has been leveled and floated, concrete finishers press an edger between the forms and the concrete and guide it along the edge and the surface. This produces slightly rounded edges and helps prevent chipping or cracking. Concrete finishers use a special tool called a “groover” to make joints or grooves at specific intervals that help control cracking. Next, they trowel the surface using either a powered or hand trowel, a small, smooth, rectangular metal tool.

Sometimes, cement masons perform all the steps of laying concrete, including the finishing. As the final step, they retrowel the concrete surface back and forth with powered and hand trowels to create a smooth finish. For a coarse, nonskid finish, masons brush the surface with a broom or stiff-bristled brush. For a pebble finish, they embed small gravel chips into the surface. They then wash any excess cement from the exposed chips with a mild acid solution. For color, they use colored premixed concrete. On concrete surfaces that will remain exposed after the forms are stripped, such as columns, ceilings, and wall panels, cement masons cut away high spots and loose concrete with hammer and chisel, fill any large indentations with a Portland cement paste, and smooth the surface with a carborundum stone. Finally, they coat the exposed area with a rich Portland cement mixture, using either a special tool or a coarse cloth to rub the concrete to a uniform finish.

Throughout the entire process, cement masons must monitor how the wind, heat, or cold affects the curing of the concrete. They must have a thorough knowledge of concrete characteristics so that, by using sight and touch, they can determine what is happening to the concrete and take measures to prevent defects.

Concrete, segmental paving, or terrazzo work is fast-paced and strenuous, and requires continuous physical effort. Because most finishing is done at floor level, workers must bend and kneel often. Many jobs are outdoors, and work is generally halted during inclement weather. The work, either indoors or outdoors, may be in areas that are muddy, dusty, or dirty. To avoid chemical burns from uncured concrete and sore knees from frequent kneeling, many workers wear kneepads. Workers usually also wear water-repellent boots while working in wet concrete.

MIRG.org 1-888-802-6376 e-mail

www.MIRG.org • Site Map • About Us • Contact Us • Links • Disclaimer